Web interface: Quick access to the Ethernet data logger
MSX-ilog-xx-xx
www.addi-data.com
37
ADDI-DATA
®
PARTNER FÜR PRÄZISION
4.3.5 “Trigger configuration” tab
Fig. 4-8: Acquisition: Trigger configuration
On this tab, you can configure the triggers. These are mechanisms that enable you to acquire the data
at a given time and to start the acquisition when an event occurs. For each trigger, you can specify the
following settings:
•
Activate:
Click on the toggle switch button to activate the trigger.
•
Pre-trigger acquisition:
There is a pre-trigger saving mechanism, which allows you to acquire
x values before the start trigger occurs.
•
Pre-trigger channels:
You can specify which of the selected channels should be acquired before
the start trigger occurs.
•
Start configuration:
Start type:
Each acquisition is started by a trigger event. From the following two categories,
you can select the desired type of trigger:
o
Analog:
The acquisition is started when the value of the selected channel (“Channel”) is
higher or lower than (“Type”) the value defined by you (“Value”).
o
Digital:
The acquisition is started when there is a rising or falling edge at the digital input
of the MSX-ilog data logger. You can define the number of edges (“Number of rising
edges” or “Number of falling edges”) after which the acquisition should be started.
•
Acquisition:
Channel:
You can select the channels that should be acquired when a trigger occurs.