Web interface: Quick access to the Ethernet data logger
MSX-ilog-xx-xx
www.addi-data.com
38
ADDI-DATA
®
PARTNER FÜR PRÄZISION
•
Stop configuration:
Stop type:
Each acquisition is stopped by a trigger event. From the following three categories,
you can select the desired type of trigger:
o
Analog:
The acquisition is stopped when the value of the selected channel (“Channel”) is
higher or lower than (“Type”) the value defined by you (“Value”).
o
Digital:
The acquisition is stopped when there is a rising or falling edge at the digital input
of the MSX-ilog data logger. You can define the number of edges (“Number of rising
edges” or “Number of falling edges”) after which the acquisition should be stopped.
o
Time:
The acquisition is stopped as soon as the time (in seconds, milliseconds or
microseconds) defined by you (“Time elapsed”) has elapsed.
NOTICE!
After setting all parameters, you have to click on the
“Save configuration” button above.
4.3.6 “Saving modes” tab
Fig. 4-9: Acquisition: Saving modes
For each of the real and virtual channels, you can choose between three saving modes:
•
View only:
The values of the channel are not saved and thus can only be viewed live on the
“View” tab.
•
Save all the time:
The values of the channel are acquired and saved all the time.
•
Trigger mode:
The values of the channel are only saved during an acquisition that is started and
stopped by a trigger. This mode is preselected if you have activated a trigger for the channel.
NOTICE!
After setting all parameters, you have to click on the
“Save configuration” button above.
