46
OOS, Auto, Man, and so forth). Specifically, you can follow the user manual of PA transmitter to modify related parameters.
(2) Calibration
Click
, then a function menu will pop up. Select "Calibrate" in the function menu to enter the calibration
interface.
You can calibrate the PA transmitter on the calibration interface. Before performing calibration on the PA
transmitter, please refer to relevant description of adjustment (Trim) part in the user manual of PA transmitter.
3.4 Electrical output
You can click a corresponding electrical output icon in the module display/hide operation area on the top status bar, to
display/hide the electrical signal output module. When the electrical output is displayed, the corresponding icon on the
status bar will be highlighted. When the electrical output is hidden, the corresponding icon will be dim and when signals
are being outputed, the output arrow on the icon will flicker.
1. Changing the range
Click the range area on the left side of the measurement area to switch the output item. The calibrator supports 0~25mA,
0~16V and 16~30V power output.
2. Connection: Connect the electric circuit as shown in Figure 3-14.
3. Enabling loop power (for current supply only)
According to the connection mode, press the
key and select whether to enable loop power.
Power will be supplied as soon as loop power is enabled.
4. Input of the target set value
When the pressure output module is hidden, press the
key to enter the setup interface of electrical output
Summary of Contents for 761A
