I.
DigiCopier III Overview
There are four buttons and an LCD on the panel of DigiCopier III.
1 – LCD shows a function or a message.
2 – it is used to scroll up function menus.
3 – it is used to scroll down function menus.
4 – it is used to execute a function.
5 – it is used to cancel a function.
II.
Connecting the power cable and turning on the DigiCopier III
a.
Connect the power cord provided from the wall outlet to the back of the
DigiCopier
III.
b.
A main power switch is located at the back of the tower. Turn the switch on. Another
auxiliary power switch is located on the front of the tower.
III.
Steps for the Copying Process
Note: may not able to copy-protected Blu-ray, DVD or CD.
Step
1
Turn on the DigiCopier III by pressing the auxiliary power switch.
Step
2
Insert media you wish to duplicate into the source tray on the top.
Step
3
Populate the destination trays with blank CDs, DVD or Blu-ray
media. A rewritable Blu-ray or DVD containing old data can also be use,
but the old data will be automatically erased.
Step 4
After the Blu-ray or DVD-ROM and DVD writers detect DVDs, press ENT button to start copying.
LCD will show the copying information as follows.
When copying is in progress, MB and time will decrease while the percentage of completion will increase.
“MB” means the size of data that you want to copy.
When copying comes to an end, LCD will show the results as follows. The DVDs that were successfully
copied will eject automatically.
Copy-DVD 0%
4213.4MB 7:30
Copy
OK: 07
ENT
ESC
Duplicator Panel
1
2
3
4
5
ENT
ESC
ENT
ESC
