www.addonics.com
Technical Support (M-F 8:30am - 6:00pm PST)
Phone: 408-453-6212
Email: www.addonics.com/support/query/
Drive InstallationGuide
Step 1.
Use a Philips screwdriver to
turn the cover securing screw
clockwise into the "OPEN" position.
Step 2.
Slide the aluminum cover
towards the back end of the Diamond
enclosure and remove it.
Step 3.
For SATA Drive: Carefully
place the SATA hard drive with the
label facing up into the Diamond
Enclosure. Push the hard drive
towards the back end to secure the
drive connectors onto the Diamond
enclosure’s SATA connector.
For IDE Drive
NOTE:
Configure your IDE hard drive as Master
device.
For 3.5" drives, Connect the 4-Pin
Molex cable to the power connector
on the IDE hard drive. For 2.5"
drives, connect the 44 pin to 40
pin adapter to the hard drive,
making sure to align the key
position, then connect the power
cable from the Diamond enclosure
to the adapter. Carefully place the
IDE hard drive with the label
facing up into the Diamond enclosure.
Push the hard drive toward
the back end to secure the drive
connectors onto the Diamond
enclosure’s IDE connector.
