Stereo Sound & CD-ROM
the computer will be unable lo access the CD-ROM drive. For
example, you might use:
O C:\BIN\MSCDEX.EXE /D:MSCD000 /L:f
Normally, the CD-ROM drive is assigned the next available drive
letter
011
the computer after the floppy drives, hard drives, RAM
drives, etc. Therefore you only need to use this option if it is
necessary to assign a drive letter beyond the last letter in use.
Step 3. Create two sub-directory BIN & DEV under the root
directory on your boot hard disk ( drive C in general ). Copy
both files CDMKE.SYS to the subdirectory BIN &
MSCDEX.EXE to the
subdirectory DEV from the
subdirectory \CDROM\SON Y on the floppy diskette.
If you are installing the CD-ROM drive in a networked system, please
consult your system manager or system setup for proper drive
specifications in Step 1 to Step 3.
4.4.2 SONY Audio Utility Installation
To install the audio utility, von may insert the diskette to the drive
that you selected. Then change to A or B drive, where the floppy
diskette is in, by entering the following command at the system
prompt:
O C:\>A: [Enter]
O A:\>cd \SONYUTIL [Enter]
or
3 C:\>B: [Enter]
O B:\>cd \SONYUTlL
Then, assuming A drive is used, do the following;
O A:\SON YUTIL>IN STALL [Enter]
1,
You will be prompted to select the target drive and subdirectory to
which the audio utility software will be copy.
Afterwards, you will be asked to enter the CD-ROM drive letter and
^ »
the monitor type J.e., color or mono. The CD-ROM drive letter
should be the same as the one specified in the Autoexec.bat file, (see
Step 2 on page 16)
Page - 19
