1.3
About this Manual
The purpose of this manual is to make the new WebNet owner acquainted with the WebNet
start kit and get started using it
1
. First, in section 2 we unpack and identify the parts of
the start kit. Then, in section 3 we install the unit and connect to it with a web browser.
Sections 4, 5 and 6 are a tour round the various configuration and monitoring/statistics
pages of the WebNet. In section 7 we look at the basics in writing and running scripts for
making dynamic web pages. In section 8, we try to get a “hole through” to the RS-232
interface. Section C contains references to further information.
Updated information, documentation and service can be found on the I/O Consulting’s
WebNet home page [3]
http://webnet.iocon.dk
. See also I/O Consulting’s home page [2]
http://www.iocon.dk
for information on other services offered by I/O Consulting.
1
Most of the information in this manual applies to version 1.93, or later, of the WebNet software. Func-
tionality, user interface and specifications may change in later versions.
8
WebNet User’s Guide
Summary of Contents for Electronic Device WebNet
