M118000-01-210305-Rev002-UM-en
Seite
29
von
112
7.2.2 Switching off with key
To switch off the scale, press and hold down the ON/OFF key for about 2 seconds.
The scale automatically saves the last settings used.
7.3
Correct weighing
Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display.
Place the baby to be weighed as centrally as possible on the weighing surface. The weight can be
read off directly after standstill.
7.4
Hold function
With the Hold function (automatic hold function), the determined weight is still displayed even after
the scale is unloaded).
Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display.
Briefly press the HOLD key. The symbols
(non-calibratable function) and
Hold
additionally
appear on the display.
Start the weighing process.
The end of weight determination is indicated by the now flashing
Hold
symbol.
The weighing result is permanently shown on the display (even after the scale has been unloaded)
until the following weighing procedure or until the scale is (automatically) switched off.
NOTES
:
If multiple weighings shall follow each other in the hold function, it is not necessary
to switch the hold function off and on again each time. However, the scale must
have reached zero once before it is loaded again. When the scale shows the
symbol >0< on the display, the next weighing can begin.
If the weighing procedure was started without using the hold function, this can still
be switched on by pressing the HOLD key even if the scale is already loaded.
To deactivate the hold function, briefly press the HOLD key. The symbols
and
Hold
will no
longer be displayed.
7.5
Tare function
The tare function does not take into account any additional weight placed on the scale.
Switch on the scale with no load. Wait for "0.00 kg" and the symbol >0< to appear on the scale
display.
Place the additional weight (e.g. towel) on the scale and briefly press the TARE key. The display
will blink temporarily and then "0.00 kg" will appear on it. The symbol
Net
will light up on the
display.
Remove the additional weight from the scale. The display shows „-----“.
Place the baby with the additional weight (e.g. towel) on the scale. The scale determines the weight
of the baby without the additional weight.
Summary of Contents for M118000
Page 2: ......
