M403660-211129-Rev006-UM-e
8
Print out a record
The scales must be at standstill. The standstill status symbol
must appear at the screen. Press the
ENTER key to send the data to the serial interface.
Note: Printing is not possible if the net weight is 0. The print function only produces one print-out. A reset
is required to print out another copy.
Error Messages
Error Codes
Description
Solution
Load cell wires to indicator are
incorrectly connected; or shorted, or
opened; or ADC/ load cell are being
damaged
Make sure wires are in good order
and condition and correctly
connected. Replace load cell or
ADC chip. Service is required.
Weight reading exceeds the zero limit
after switching the scale on.
Make sure scale platform is empty.
Weight reading is below the zero limit
after switching the scale on.
Install platform on scale.
Otherwise the zero calibration/
adjustment have to be done by
authorized personnel.
Weight reading exceeds load limit.
Reduce load on scale until weight
value can be displayed.
Weight reading below load limit.
Service by authorized personnel
required.
Configuration or Calibration parameters
are not correctly set.
Contact your local dealer / supplier
for calibration purpose.
Capacity parameters are not correct.
Contact your local dealer / supplier
for a new set-up.
Calibration error. The incoming signal of
loaded weight is too small, too big,
unstable or un-linear.
Contact your local dealer / supplier
for a new set-up.
Not turn on.
Power cord is not properly connected.
Power outlet not supplying electricity.
Batterie is discharged. Other failure.
Check power cord connections.
Make sure power cord is plugged
into the power outlet. Check power
source. Replace batteries.
Cannot zero the
display or will
not zero when
turned on.
Load on scale exceeds allowable limits.
Load on scale is not stable.
Load cell damage.
Remove load from the scale.
Wait for load to become stable.
Service required.
No Battery
symbol or
display of Lo.bAt
Batteries are discharged.
Charge batteries.
