PFA-200702-Rev004-UM-en
8
Battery Alert
It is also possible to provide the scale with voltage via the integrated battery.
Should the voltage be too low the battery symbol in the display will indicate.
The batteries should be charged or exchanged immediately.
PRESETTING OF THE SCALE
Presetting mode:
It is possible to set a plenty of presetting.
Press and hold the „Zero-Button“ while turning on the
scale to get into the presetting mode.
The scale will switch to presetting mode without
running the test routine.
Press PCS-button to change the value from left to
right.
Press the UNIT-button, to enter the next parameter.
Press PRN-button in order to save settings.
The scale will run the test routine and change to
weighing mode.
All presetting which are not described in the consecutively details may be
conducted by authorized personnel only.
Acoustical alarm setting
You may set a minimum and maximum weight. An acoustical alarm sounds if the weight of the
weighing good is below the entered minimum value or above the maximum value.
The minimum value has to be lower than the maximum value.
Setting up the minimum weight
Start the presetting mode as described before.
Set the minimum value.
Press PCS-button to change the value from left to right.
The value you want to set is blinking.
Press „-0-“-button to increase the value by one.
Press „TARA“-button to decrease the value by one.
Press the UNIT-button to save the presetted value and
change to the next step.
