www.adeept.com
64
4.InstallPython3.7inthePC
4.1.Install Python3.7
So far there are two versions of Python: 2.X and 3.X. The graphical UI of the terminal
control is written in Python 3.7 and it supports multiple platforms. Here we'll focus on the
installation of Python 3.7 under Windows.
Download Python 3.7:
Click through
Downloads
->
Download Python 3.7.0
.
Install it after download is done. Python will configure the environment variables during the
installation.
*Pay attention to the 32-bit or 64-bit of your system when downloading Python - choose
the corresponding Python version based on your own system.
4.2. Run the RaspArm
Start
Switch on the RaspArm.
Note: The moment the power is turned on, the arm will swing randomly at a small range. Please
keep your eyes away from the swing range of the arm as much as possible. After the Raspberry Pi
is turned on, the servo on the arm will drive the corresponding joint to swing to the initial
position successively, while the LCD screen will display the port number of the servo to be moved
and the remaining time of the movement. This is a security feature that is turned on by default,
and you can turn it off by changing the code.
The gamepad of RaspArm has four input modes:
Rotation
,
Short-press
,
Long-press I
and
Long-press II
.
Summary of Contents for RaspArm
