K3590-3V1 3/00
REMOTE KEYPADS
6150PL3 & 6160PL3
INSTALLATION GUIDE
Keypad Features
6150PL3
Fixed-Word
6160PL3
2-Line Alpha
Backlit Display
YES (See Note 1)
YES (See Note 1)
Dedicated Function Keys
YES
YES
Built-in Sounder
Piezo
Speaker
Notes1.Permanent display backlighting is an option on some controls (see the control's instructions for details).
GENERAL INFORMATION
WIRING AND INSTALLATION
The 6150PL3 and 6160PL3 are addressable Remote
Keypads designed for use with SecurityLink control panels.
Addresses are set via the keypad keys.
The keys on the keypads are continuously backlit for
convenience.
KEYPAD DISPLAYS AND LEDS
The keypads have the following display features:
Model
Fixed
Word
Display
2-line
Alpha
Display
2-digit
Zone
Identifier
Custom
Zone
Descriptors
6150PL3
X
X
6160PL3
X
X
The following table shows the LEDs and their functions:
LED
Function
Red
Lights when the system is armed in any mode
Green
Lights when the system is "ready" to be armed.
SPECIAL FUNCTION KEYS
The keypads also feature function keys. These keys may be
programmed for panic alarms or other special functions
such as macros. See the control's instructions for details.
Function Key
Corresponding Key
Pair
A
[1] & [*]
B
[*] & [#]
C
[3] & [#]
D
NONE
The keypads can be surface mounted directly to a drywall, or to
a single- or double-gang electrical box.
1.
Remove the case back by pushing down two "snaps."
See diagram below.
2.
Route wiring from the control panel through the
opening in the case back.
3.
Mount the case back to a wall or electrical box.
4.
Wire directly from the keypad’s terminal block to the
terminal block on the control board. Wire functions are
marked next to terminals. Labels are as follows: DI Data
In to Control Panel, - Ground, + Aux. Power Plus, DO Data
Out of Control Panel. See the control panel’s Installation
Instructions for more complete details.
5.
Re-attach the keypad to its case back.
1
2
3
6
5
4
8
9
7
0
*
#
OFF
AWAY
STAY
MAX
TEST
BYPASS
INSTANT
CODE
CHIME
READY
ARMED
READY
A
B
C
D
MOUNTING RELEASE SNAPS
(Remove case back by pushing
up the 2 "snaps" along the
keypad's bottom edge and
pulling the case apart.)
SIDE VIEW
Function keys must be held down for at
least 2 seconds to activate an alarm, key
pairs activate immediately.
