Installing the Roxtec Cable Seal Assembly
Adept Cobra s800 Inverted Robot User’s Guide, Rev C
109
5. Temporarily remove the pressure screw, slip washer, and washer.
6. Adapt the modules which are to hold cables by peeling layers until you obtain the
gap shown in 7.
7. There must be a 0.1 - 1.0 mm gap between the two module halves
when held against the cables.
8. Thoroughly lubricate all modules, both inside and outside, with Roxtec
Lubricant.
CAUTION:
The Roxtec cable assembly will not seal if
adequate Roxtec lubricant is not used.
Application of the Roxtec lubricant is
necessary for obtaining a water-tight
seal. Use the lubricant liberally.
Wait at least 24 hours for the lubricant
to set with the Roxtec modules.
