20
Before effecting any intervention on the electrical parts of the appliance, the connection to the network must be
interrupted.
Important
To connect the power supply cable do not
unscrew the screws
fixing the cover plate behind the terminal
block.
Important
The connection of the appliance to earth is mandatory.
The manufacturer declines
all responsability for
any inconvenience
resulting
from then one observance of this condition.
Connecting the hob to the mains Make sure, that the data on the rating
plate (V) matches your supply voltage.
The connection to the power supply must be carried out by a qualified
electrician in accordance with the relevant standard or with a single-pole
circuit breaker, as described below:
The electrical connection must be made properly and in accordance with
the applicable safety regulations.
To connect the hob to the mains power supply, do not use adapters,reducers
, or branching devices, as they can cause overheating and fire.
The cable must not be kinked or pinched.
The power supply cable must not touch any hot parts and must be positioned
so that its temperature will not exceed 75 at any point. The cable must be
checked regularly.
Important
This appliance must be earthed.
Warning
If the power supply cable is damaged, it must be replaced only by an authorised service agent in order to
avoid a hazard.
Warning
If the cable is damaged or needs to be replaced, this must be done by a qualified electrician with the
correct tools.
The installer must use an HOSGG-F type power cable.
After installation, the connection cable and the underside of the hob must no longer be accessible.
6.32 Connecting the range to the mains
1.
Unscrew the rear casing screws and remove
the casing to access the terminal board.
2.
Replace the cable.
3.
Make sure that the cables (for the oven
or any hob) follow the best route in order to
avoid any contact with the appliance.
N.B.
The earth conductor must be left about 3 cm
longer than the others.
Summary of Contents for ALTAY900
Page 1: ...ALTAY900...