- 4 -
- 5 -
Item Description
Qty Item Description
Qty
APU
1
Fill valve flow restrictor, blue
1
Front cover
1
Rubber hose sealing washer, to
be used with item C
1
Flexible hose, G ½ 15 mm
compression
1
Cable tie
2
M6 screw
1
Instruction book
1
Wall mounting plate
1
A
E
C
B
D
H
G
F
I
1 IMPORTANT FACTS:
READ BEFORE COMMENCING PUMP INSTALLATION
A
Water storage capacity .
1 .11 The APU Mini has a usable water volume of approximately 2 litres; the length
of time the APU takes to pressurise a system will be dependent on the pressure
differential between the cold fill and set pressures and also the refill rate of the tank .
1 .12
Ensure the pumps are primed as described in the priming section before
starting, to avoid causing damage to the pump . See Section 6 .20 Hydraulic
commissioning .
B
Water temperature
This unit is designed to pump cold water only which should not exceed the following
values:
1 .13 The maximum allowable water temperature is 23
o
C (see Technical Section) .
1 .14 The minimum allowable water temperature is 4
o
C .
C
Pipework - General
1 .15
Do not drill holes or put fastenings into the APU Mini tank, this will cause
leakage .
1 .16
Secure pipework: Ensure pipework to and from pump is independently
supported & clipped to prevent forces being transferred to inlet and outlet
branches of the unit .
Do not secure pipework to the APU Mini, this will cause
damage and possible leakage .
1 .17
Flux: Solder joints must be completed and flux residues removed prior to APU
Mini installation
(flux damage will void any warranty) .
1 .18
Pipework design: Care should be taken in the design of pipework runs to
minimize the risk of air locks e .g . use drawn bends rather than 90
o
bends .
1 .19
DO NOT introduce solder flux to flexible hose, tank, pump or any
parts manufactured from plastic .
1 .20
DO NOT allow contact with oil or cellulose based paints, paint thinners or
strippers, acid based descalents or aggressive cleaning agents .
1 .21
DO NOT bend the flexible hose beyond 90
o
. It must be installed as
detailed,
DO NOT kink . See Installation Section 4 .14 .
D
Plumbing installation regulations
1 .22 The plumbing installation must comply with the current water and building
regulations .
1 .23 The plumbing installation must be installed by a qualified person .
E
System filling
1 .24 The APU Mini is
NOT DESIGNED TO FILL THE SYSTEM FROM EMPTY .
It is only intended to top up the system after occassional water leakage .
Systems should be filled via a dedicated filling loop .
Fig . 1
IMPORTANT: With the appliance removed from its packaging check for any damage prior
to installation. If any damage is found contact ADEY
Commercial Ltd within 24 hours of
receipt.
A
D
C
Front cover removed for clarity
B
E
Electrical rating
plate & serial
number
G
H
F
CHECKLIST
Note:
Your product may vary slightly from the picture above.
