Industrial
Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO:
www.adfweb.com
Phone +39.0438.30.91.31
User Manual
OPC UA Client / J1939
Document code: MN67B17_ENG Revision 1.000 Page 16 of 30
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, OPC UA and
J1939.
By Pressing the “
Set Communication
” button from the main window for SW67B17 (Fig. 2)
the window “Set Communication” appears (Fig. 3).
The means of the fields for “OPC UA Client” are:
In the field “
IP Address
” the IP address for OPC UA side of the converter is defined;
In the field “
SubNet
Mask
” the SubNet Mask for OPC UA side of the converter is
defined;
In the field “
Gateway
” the default gateway of the net is defined. This feature can be
enabled or disabled pressing the Check Box field. This feature is used for going out
of the net;
In the field “
DNS
” the IP Address of the DNS server is defined. This feature can be
enabled or disabled pressing the Check Box field.
The means of the fields for “J1939” are:
In the field “
Baudrate
” the data rate of J1939 is defined;
In the field “
TimeOut Data
” a time is defined. When a J1939 message is not
received in this time, the data on MQTT side are set to 0xFF;
If the field “
Enable Peer to Peer
” is checked, the gateway will mask the Source
Address of the J1939 messages received.
In the field “
ID Device J1939
” the ID of J1939 side of the converter is defined.
The means of the fields for “NTP (Network Time Protocol)” are:
In the field “
Server URL
” the URL or the IP Address of the NTP Server is defined;
In the field “
Poll Time (seconds)
” the polling time for the time synchronization is
defined.
Figure 3: “Set Communication” window
