Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
LoRaWAN / SNMP Manager
Document code: MN67D40_ENG Revision 1.000 Page 20 of 28
SNMP SET ACCESS:
By Pressing the “
SNMP Manager
” button from the main window for SW67D40 (Fig. 2) the window “Set SNMP Manager Access” appears
(Fig. 5).
The meaning of the fields in the window are the follows:
If the field “
Enable
” is checked, the SNMP request is enabled;
In the field “
IP Address
” the address of the SNMP Agent device to read/write is defined;
In the field “
Version
” the SNMP version used to send the SNMP request (1 or 2 is allowed) is defined;
In the field “
Community Name
” the Community Name used for the SNMP request is defined (selectable or editable manually);
In the field “
OID
” the OID to read/write from/to the SNMP Agent device is defined;
In the field “
Type
” the type of data to read/write (‘String’ or ‘Int’) is defined;
In the field “
Mode
” the type of SNMP request used (‘Get’, ‘Set’ or ‘Trap’) is defined;
By checking the field “
On Change
” the SNMP request (only for ‘Set’ Mode) is made only if EtherCAT data written by the EtherCAT
Master are changed;
By checking the field “
OnCMD
” the SNMP request is sent only when a EtherCAT command for the associated variable is received;
If the field “
On Timer
” is checked, the SNMP request is sent cyclically;
In the field “
Time
” the delay in ms between two SNMP requests is defined (if “On Timer” is checked);
In the field “
Position
” it is possible to select the position where take/save the data from/to the internal memory array;
Figure 5: “Set SNMP Manager Access” window
