GB
GB
OPTIONAL ACCESSORIES
Front light and relative switch.
3SD – Solution saving system dispenser.
Squeegee “V”-type.
Incorporated battery charger.
BEFORE USE
HANDLING OF THE PACKED MACHINE
The machine is supplied with suitable packing fore-
seen for fork lift truck handling.
The total weight is 292kg.
Packing dimensions:
Base:
178 cm x 93 cm
Height:
138 cm
ATTENTION:
Do not place more than 2 packings on top of each
other.
UNPACKING OF THE MACHINE
1. Remove the external packing.
2. Unscrew the brackets (1+2) that secure the ma-
chine to the pallet.
3. Move the machine backwards, as indicated in the
figure, avoiding heavy contacts to mechanical parts.
4. Keep the pallet and the brackets for eventual
transport.
ACCESS TO THE BATTERY COMPARTMENT
1. Bring the machine on a levelled surface.
2. Rotate the seat platform forward and hook the
bar.
Having finished any intervention, to close the bat-
tery compartment, reposition the seat platform.
To install into the compartment a battery box, it is
necessary to:
1. Rotate the seat platform forward and hook the
bar (2) into position A.
2. Remove the holder (1) by unscrewing the two
wing nuts under the platform.
3. Pull outwards the releasing lever (3) of the seat
making slide the seat body (4) up to the highest po-
sition.
4. Rotate further the platform in order to hook the
bar (2) into position B.
In this way it will be possible to handle the batteries
with suitable lifting equipment.
BATTERY INSTALLATION
The machine is equipped either with batteries in se-
rial connection or elements of DIN-type assembled
together and connected in series for a total of 24
Volt, placed in its appropriate compartment under
the seat platform and must be handled using suita-
ble lifting equipment (due to weight, considering the
type of batteries chosen, and coupling system).
The batteries must be in accordance with CEI 21-5
Norms.
ATTENTION:
The machine and its battery check card foresee the
use of traditional lead batteries.
CHECK THE SETTING OF THE CHECK CARD (see under
paragraph "BATTERIES CHARGE LEVEL INDICATOR").
In case of GEL batteries installation, it is necessary to
MODIFY THE SETTING of the electronic check card
(see under paragraph SETTING OF THE BATTERY
CHECK CARD”).
ATTENTION:
Strictly follow manufacturer/distributor indications
for the maintenance and recharge of the batteries.
All installation and maintenance operations must be
executed by specialized staff, using suitable protec-
tion accessories.
For batteries installation it is necessary to reach the
battery compartment as indicated under paragraph
“ACCESS TO THE BATTERY COMPARTMENT”.
1. Place the batteries in its compartment.
2. Connect the terminals, respecting the polari-
ties, avoiding contact with other parts that could
create short circuit.
BATTERY RECHARGER
Make sure that the battery recharger is suitable
for the installed batteries both for their capaci-
ties and type (lead/acid or GEL and equivalent).
In the plastic bag containing the use and mainte-
nance you will find the coupling connector for the
recharger. It must be assembled onto the cables of
your recharger, following the instructions given by
the manufacturer.
21
Summary of Contents for coral 70s
Page 2: ......
