11
To assemble the covers, it is necessary to proceed as follows:
1.
Take off the clips (1) present on the pins (2) fixed to the brushes
base.
2.
Take off the cover from the brushes base.
For the assembly it is necessary to proceed inversely with above-
mentioned operation.
ADJUSTING THE SPLASH GUARDS
When the brushes base is lowered on the floor the splash guards have
to slightly touch the floor. To adjust them proceed as follows:
1.
Loosen the rings (2).
2.
Turn the knob (1) clockwise to raise the splash guards or
counterclockwise to lower them.
3.
Fasten the ring (2).
ASSEMBLING THE BRUSHES
To assemble the brushes, it is necessary that the brushes base is in the
lifted position. If it is not lifted, proceed as follows:
Without the operator seated, turning the key switch clockwise, the
display comes on and after 3 seconds all working groups come off
automatically and are lifted from the floor.
Switch off the machine turning the key counterclockwise.
With the brushes base group in lifted position lock the brushes
rotating them as in the picture below.
For a longer life of the brushes we suggest to invert daily their
position. Whenever brushes result to be deformed we suggest
reassembling them in the same position, in order to avoid that the
different inclination of the bristles causes excessive motor overload
or troublesome vibrations.
ADJUSTING THE STEERING WHEEL
Using lever (1) it is possible to
unlock the steering wheel to
adjust the distance from the
operator.
To increase or decrease the lever
locking strength, turn the
ferrule.
ADJUSTING THE FOOTBOARD
Using the knob (1) it is possible
to adjust the height of the
footboard.
