27
ADICOS GSME
405-2010-003 EN52
InSTALLATIOn
5.5
Retrofitting of BMZ modules
NOTICE!
Detector electronics and BMZ modules are sensitive assemblies, which can be
damaged on contact due to
electrostatic discharge
.
•
De-energize the entire detector system for any wiring
and secure against
unintentional reactivation!
•
Apply ESD measures when working on the detector electronics!
•
Do not touch electronic components!
The electronics of the ADICOS GSME features a slot for BMZ modules. Depending on the
ordered configuration, the detector electronics is populated with the necessary module in the
factory configuration. However, BMZ module retrofits are required on site in special cases.
In addition to the electrical installation, it must be observed that a configuration change of
the detector using the ADICOS service software is usually also required to use the module
functionalities.
Retrofitting the BMZ module
1
Using the PZ2 screwdriver, loosen the enclosure screws
in the detector cover
The screws remain in the cover.
2
Carefully remove the enclosure cover with the detector
electronics
The plug connector for detector connection remains
connected.
3
Insert the BMZ module into the BMZ module slot
on the detector board
4
Close the detector enclosure
Summary of Contents for GSME-M4
