STEP2
FIT THE BACKREST BRACE (7) ONTO BACK ADJUSTMENT SLIDER (3) AND SECURE WITH HEX BOLT M10*70MM
(20), WASHER M10*25MM (21) AND HEX NUT M10*8MM (5).
FIT THE MIDDLE HOLE OF BACKREST SUPPORT (6) ONTO THE END OF BACKREST BRACE (7), AT THE SAME
TIME ALSO FIT THE END HOLE OF BACKREST SUPPORT (6) ONTO TOP SHAFT OF CENTRAL BRACE (1) AND
HOLD THEM. THEN FIT THE BACKREST (8) ONTO BACKREST SUPPORT (6) AND SECURE WITH 4 HEX BOLT
M8*40MM (23) AND 4 WASHER M8*25MM (29).
**PLEASE FULLY TIGHTEN ALL FASTENERS OF ENTIRE EQUIPMENT.
Summary of Contents for ADBE-10234
Page 1: ...ADBE 10234 UTILITY BENCH ASSEMBLY INSTRUCTONS ...
Page 2: ...PARTS CHECK LIST ...
Page 3: ...HARDWARE PACK CHECK LIST ...
Page 4: ...EXPLODED DIAGRAM ...
