OPERATING AND USER MANUAL Q-12 CoaXPress series
________________________________________________________________________________________________________________
_________________________________________________________________________________________
Adimec
8
2 SAFETY PRECAUTIONS
NOTE:
A CMOS sensor camera is a sensitive device. Please read the following precautions carefully before
continuing unpacking or operating the camera.
NOTE:
It is advised to unpack and handle the camera in a clean ESD protected working area.
NOTE:
It is advised to read the whole manual before using the camera.
NOTE:
Always keep the sensor cap in place as long as no lens is attached.
NOTE:
Remove the lens cap just before the lens is screwed on the camera. It is advised to perform this
operation in a clean room or clean bench.
NOTE:
Never touch the CMOS sensor surface. The cover glass is easily damaged and the CMOS sensor can
be damaged by ESD.
NOTE:
In case the camera is used as a subsystem, it is advised to include the text of this chapter in the
assembly documents of the main system.
2.1 Cleaning of the CMOS sensor
The cleaning of a CMOS sensor is a difficult task with a high risk on permanent damage to the camera.
NOTE:
It is advised to prevent cleaning the CMOS sensor as much as possible.
NOTE:
Damage of the CMOS sensor due to scratches on the cover glass or ESD is not covered by warranty!
All cameras are checked for cleanliness in our factory before shipment.
Proper handling instructions during system assembly can prevent the CMOS sensor from getting contaminated.
Should cleaning of the CMOS sensor be necessary, please refer to Appendix A: CMOS Sensor cleaning
instructions.
2.2 Camera housing
Thermal interfacing
The actual housing temperature achieved depends on the thermal configuration of the camera and the system in
the end-user application. Provisions as to guarantee maximum housing temperature are therefore a
responsibility of the end-user.
NOTE:
The housing temperature should not 50° Celcius.
NOTE:
Mount the camera on a substantial (preferably metal) body that can act as a heat sink.
NOTE:
Create airflow over the camera e.g. by using a fan.
Cleaning of the camera housing
The camera housing should NEVER be immersed in water or any other fluid. For cleaning, only use a light moist
tissue.
