25
Adirondack Spas
®
OWNER'S MANUAL
If a Temperature button is pressed and held when the temperature is flashing, the temperature
will continue to change .
When the spa is first powered up the water temperature will not be displayed until the pump has
been running for at least two minutes . The Default Water Temp from the factory will be 80*F in
HIGH RANGE .
The temperature shown on the display without pressing the Warm or Cool button reflects the
temperature of the water at that particular moment .
hold Mode
“Hold Mode” is used to disable the pumps during service functions like cleaning or replacing the
filter . Press TEMP to desired hold temperature, Press LIGHT repeatedly to HOLD, then Press
TEMP to count down . The clock will count down from 60 minutes .
lock and unlock Mode
Locking the panel prevents the spa from being used; it also prevents unwanted temperature
adjustments . All automatic functions are still active . Locking the temperature allows Jets and
other feature to be used, but the Set Temperature and other programmed settings cannot be
adjusted . Temperature Lock allows access to a reduced selection of menu items, which include
Set Temperature, FLIP, LOCK, UTIL, INFO and FALT LOG .
To engage LOCK MODE, Press TEMP, Press LIGHT repeatedly until LOCK appears, then
Press TEMP . To continue, Press LIGHT to toggle TEMP or PANL, Press TEMP to toggle ON
or OFF, then Press LIGHT to exit menu .
Note: To Unlock (UNLK) the above features, Press TEMP, then LOCK appears on
display, Press and hold TEMP while pressing LIGHT twice . UNLK screen appears, and
then will exit to main screen in approximately 3 seconds .
SETTing 24 hour clock
This action changes a 12 hour clock to a 24 hour clock .
Press TEMP to initiate a flashing display . When the temperature flashes, Press LIGHT repeatedly
until PREF appears . Press TEMP at PREF . Press LIGHT at the F/C menu . Press TEMP to
toggle between 24 and 12 hour . Press LIGHT to:
1) enter choice,
2) again to exit PREF menu,
3) again to exit UTL menu and return to main menu.
TEMpErATurE F/c diSplAY
Provides an option to choose between Fahrenheit and Celsius
To choose between Fahrenheit and Celsius, toggle between F and C in PREF menu . Press
TEMP, then Press LIGHT repeatedly until PREF appears, Press TEMP to toggle F/C choice,
Press LIGHT twice to exit to main menu .
Flip button
Pressing the panel button marked FLIP will invert the display on the panel, allowing you to read
the display from inside or outside of the spa .
