26
Adirondack Spas
®
OWNER'S MANUAL
opErATing ThE hYdro puMp(S)/JET buTTon(S)
Activate the hydro jet pump(s) for maximum hydrotherapy jet action. Press the “Jets1” button
once for low speed, twice for high speed and a third time to turn the pump off . If you spa has
two hydro jet pumps, “Jets 1” will be a two speed pump, and “Jets2” will be a single speed
pump . Pressing “Jets2” once will turn the pump on high speed, pressing “Jet2” button again will
turn the pump off .
If either pump is left running, they will turn off automatically in 15 minutes if on High speed or
30 minutes if on Low Speed .
Also, note, if you spa is in READY MODE, pump 1 low speed may turn on for at least 1
minute every 30 minutes to detect the spa temperature (polling) and then to heat to the set
temperature if needed . When low speed turns on automatically, it cannot be deactivated from
the panel; however, the high speed may be started by pressing the “Jets1” button.
clean-up cycle
When “Jets1” is manually turned on, a “Clean-Up Cycle” begins 30 minutes, on low speed,
after “Jets1” is turned off . If your spa is equipped with an Ozone Generator, it will operate with
“Jets1” on low speed .
light button
The spa light is controlled using the LIGHT button . Press the LIGHT button once to turn the
spa light on, then again to turn the light off . The LIGHT button is also used in conjunction
with temperature(s) to navigate the system menus.
optional lEd blast™ or Splash™ lighting
If your spa is equipped with one or more of these lighting systems, see the operational features
and directions located in the Blast™ or Splash™ box, or contact your dealer for instructions .
