User Manual MIC 980
Issue 21.01.2019_01
6
1.2.5
Operating mode
(also see item 8)
The controller is in operating mode. A program is currently in operation. All aspects of the program are
being controlled. All the control outputs are actuated according to the programming (
configuration /
nominal step values)
.
1.2.6
Pause mode
(also see item 9)
A program that is running is interrupted. There is no temperature control. The reason for pause mode
is shown on the status bar (see 1.5, e.g.
„Door open“). All regular
1
outputs of the controller are switched
off (relays, analogue outputs).
1.3 Display and operating panel
Be aware
Please do not operate the touch screen with sharp implements i.e. pointed fingernails,
pens/pencils, screwdrivers etc. Only use blunt, soft implements i.e. fingers, rubber pens.
The controller is sub-divided into an input/display panel and a control button panel.
1.3.1
Input and display touch panel
The
upper half is a 7“ touch display. Here you can change the different settings and information on
program data and the input screens are shown.
1.3.2
Control buttons
The control buttons allow you to navigate through the operating elements with the help of the cursor
buttons. Use the
“Cursor-Enter” button to confirm the entries you have made.
Figure 1: MIC 980
1
An exception can be outputs that have been configured as event–related outputs, e.g. the light when the door is
open.