ADJ Products, LLC - www.adj.com - 3 Sixty 2R Instruction Manual Page 27
ADJ Products, LLC - www.adj.com - 3 Sixty 2R Instruction Manual Page 26
3 Sixty 2R
System Menu
3 Sixty 2R
System Menu
Address via DMX - With this function you can adjust the DMX
address via external controller.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until “Status Settings” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Address via DMX” is dis-
played, and press ENTER.
4. Either “Off” or “On” will be displayed, use the UP and DOWN but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
To use this function follow these instructions:
To adjust the address of your unit you must first go to the
address that it is currently set to. From there you can adjust the
address. First make sure all channels are set to the value of “0”.
1. On your DMX controller set the DMX value of Channel 1 to
the value “7”.
2. Now set the DMX value of Channel 2 to the value “7” to
adjust the starting address between 1 and 255. To adjust the
address between 256 and 511 set Channel 2 to the value “8” .
3. Set the DMX value of Channel 3 to your desired start-
ing address. This will take about 20 seconds before the unit
accepts the new DMX address.
EXAMPLE: If you want the address to be 57, you must first set
the address that is currently assingned to the unit. Then set
Channel 1’s value to “7”, Channel 2’s value to “7”, and Chan-
nel 3’s value to “57”. Wait 20 seconds and the address should
change on the unit to “57”.
2ND EXAMPLE: If you want the address to be 420, you must
first set the address that is currently assingned to the unit. If
you want the set the address to 420, set Channel 1’s value to
“7”, Channel 2’s value to “8”, and Channel 3’s to “164”. (256 +
164 = 420).
No DMX status - With this function if the DMX signal is suddenly
lost, the unit will automatically go into 1 of 3 modes.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER.
2. Press the UP or DOWN buttons until “Status Settings” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “No DMX Status” is displayed,
and press ENTER.
4. Either “Hold” (Last DMX setting), “Close” (Blackout), “Music”
(Sound Active), or “Auto” (Auto Program) will be displayed, use the
UP and DOWN buttons to toggle between.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Pan Reverse - With this function you can reverse the Pan movement.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that “Personality” is highlighted, then press
ENTER. This function is used with DMX mode.
2. Press the UP or DOWN buttons until “Status Settings” is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until “Pan Reverse” is displayed,
and press ENTER.
4. Either “Off” or “On” will be displayed, use the UP and DOWN but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Tilt_L Reverse - With this function you can reverse the left head Tilt
movement. This function is used with DMX mode.
