ADJ ENCORE BURST UV IP, User Manual

18

S Y S T E M   M E N U

SET ADDRESS - In this menu you can find and set your desired DMX address.
DMX CHANNEL MODE - In this menu you can find and set your desired DMX channel mode.
NO DMX STATUS - This menu setting is used as a precaution mode in case the DMX signal is lost or 

interrupted. The operating mode chosen in this menu is the running mode the fixture will go into when 

the DMX signal is lost. Listed below are the 3 modes.

•  Hold Last - This setting will have the fixture stay in the last DMX setup.

•  Blackout - This setting will have the fixture automatically go into stand by mode.

•  Manual - This setting will go into the current manual control set up.
DIM MODES - In this menu you are able to select your desired dimmer mode and adjust the dimming 

speed time.
LED REFRESH RATE - In this menu you are able to select your desired LED refresh rate.
GAMMA - In this menu you are able to select your desired gamma setting.
DISPLAY - In this menu you you are able to activate/deactivate the display blackout and activate/

deactivate the display lock.
SERVICE - In this menu you are able to access and adjust/change: the calibration (effect adjust) and 

restore the factory settings.
MANUAL CONTROL - This menu is for manual testing and manual control. The dimmer and strobe 

can be tested/adjusted. The fixture must be set to “Manual” under “No DMX State”.
FIXTURE LIFE TIME

•  Power On Time -The TOTAL power ON running time of the unit is displayed. This time CANNOT 

be reset.

•  P-On Time-R - The CURRENT power ON running time of the unit is displayed. This running time 

may not be the same as the TOTAL power ON running time displayed under “Power On Time”. 

This time CAN be reset. NOTE: The displayed time represents the current power ON time 

since the last reset.

•  P-On Time-Reset - Reset the CURRENT power ON running time that is displayed under “P-On Time-R”.

TOTAL LED TIME

•  LED On Time - The TOTAL LED ON time is displayed. This total LED ON time CANNOT be reset.

NOTE: The displayed time represents the TOTAL LED ON time.

•  LED On Time-R - The CURRENT LED ON running time is displayed. This running time may not be the 

same as the total LED ON time displayed under “LED On Time”. This total LED ON time CAN be reset. 

NOTE: The displayed time represents the current LED ON time since the last reset.

•  LED On Time Reset - With this function you can reset the CURRENT LED ON time that is displayed 

under “LED On Time-R”.

FIXTURE TEMPS

•  Current - The current unit temperature is displayed.

•  Max Resettable - Maximum temperature that has been recorded, before reset and after reset. This 

temperature may not be the same as the temperature displayed under “CURRENT” or “MAX NOT 

RESETTABLE”. This temperature CAN be reset.

NOTE: The displayed temperature represents the highest temperature the fixture has reached 

since the last reset.

•  Max Not Resettable - Overall maximum temperature that has been recorded. This temperature 

CANNOT be reset, and could continue rise.

•  Rst Temp History - Reset the “Max Resettable” temperature.
DMX VALUES - Displays the DMX values of any DMX channel that is currently in use. NOTE: DMX value 

options depend on the current DMX channel mode setting.
SOFTWARE VERSION - The current software version is displayed.