ADJ MOD HEX100, User Instructions

ADJ Products, LLC  -  www.adj.com  - MOD HEX100 User Manual Page 23

Static Color Mode:

1.  Plug the fixture in and press the MODE button until “CLR MACS COLOR: XX” is displayed. “XX”    

    represents a number between 00-63.
2.   Use the UP and DOWN buttons to scroll through the 63 colors to find a desired color. After  

    finding a desired color, strobing can be activated by pressing the SET UP button.

3.   “STROB: XX” will now be displayed, this is strobe mode. Press the UP of DOWN buttons to fine    

    a desired strobing speed. The strobing can be adjusted between “00” (strobe off) to “15”    

    (fastest strobe).

System Reset:

This will return the fixture to its factory settings. 

1.   Plug the fixture in and press the MODE button until “OPTION” is displayed

.

2.   Press the SET UP button until “SYSRESET” is displayed.

3.   Press the UP or DOWN buttons simultaneously to reset or press the MODE button to exit. 

Dimmer Curve:

This is used to set the dimming curve used with DMX mode. See page 26 for the different dimming 
curves. 

1.  Plug the fixture in and press the MODE button until “DMX MODE ADDR: XXX” is displayed

.

2.  Press the SET UP button until “DELAY:X” is displayed. “X” represents the displayed dimmer  

    curve (0-4).

  •    0 - Standard

  •    1 - Stage

  •    2 - TV

  •    3 - Architectural

  •    4 - Theatre

3.   Press the UP or DOWN buttons to scroll through and select your desired dimming curve. 

DMX State:

This mode can be used as a precaution mode, that in case the DMX signal is lost, the operating mode 

chosen in this setup is the running mode the 昀椀xture will go into. This setting is also the operating 

mode the unit will return to when power is applied. 

1.  Plug the fixture in and press the MODE button until “DMX MODE ADDR: XXX” is displayed

.

2.  Press the SET UP button until “DMX MODE NO” is displayed. The current DMX state will be 

   displayed.
  

•  “BLACK” (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into    

    stand by mode.

  •  “HOLD” (Last State) - If the DMX signal is lost or interrupted, the 昀椀xture will stay in the last DMX    

      set up.    

  •  “AUTO” (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into  

      auto run mode.

  •  “MANUA” (Manual) - if the DMX signal is lost or interrupted, the unit will automatically go into the   

     last color set up in manual dimmer mode.
3.   Press the UP or DOWN buttons to scroll through and select a desired DMX state. 

MOD HEX100

Operating Instructions