ADJ Products, LLC - www.adj.com - MOD HEX100 User Manual Page 25
MOD HEX100
ADJ UC IR/ Airstream IR Control
The
UC IR
infrared remote gives you control of various functions (See below).
To control the fixture
you must aim the remote at the front of the fixture and be no more than 30 feet away. To use the ADJ
UC IR you must first activate the fixtures infrared sensor, to activate the sensor please see the in
-
structions on page 24.
The
Airstream IR
remote transmitter plugs into the headphone jack of your iOS phone or tablet. To
control your IR fixture you must raise the volume to the maximum on your iOS phone or tablet and
aim the transmitter at the fixture sensor and be no more than 15 feet away. After you have purchased
the Airstream IR transmitters, the app is a free download from the app store for your iOS phone or
tablet. The app comes with 3 pages of control depending on the fixture you are using. Please see
below for IR functions including the corresponding app page.
Works with App page 1
STAND BY -
Pressing this button will blackout the fixture. Press the button again to return to the
initial state.
FULL ON
-
Press this button down to fully light up the unit. Press any button to exit this mode..
FADE/GOBO
-
Press this button to switch between Color Change Mode, Color Fade Mode, and
Auto Run Mode. Use buttons 1-9 to select your desired show. Press this button twice for show 10.
Press button 1 twice for show 11.
“” and “DIMMER -” -
Use these buttons to adjust the output intensity when color macro
mode is active.
STROBE
-
Press this button to activate strobing. Use buttons 1-4 to adjust the strobe speed. “1”
being the slowest, “4” being the fastest. Press this button again to stop strobing.
COLOR
-
Press this button to activate color mode. Use buttons 1-9 to find your desired color.
1-9
-
Use buttons 1-9 to select a desired color when color macro mode is active or a desired program
when color change or color fade mode is active. Use buttons 1-4 to select a desired strobe rate
when strobing is active.
SOUND ON & OFF -
Use the buttons to activate and deactivate sound active mode. When activated
sound sensitivity is at the highest. When SOUND OFF is pressed sensitvity is at its lowest.
SHOW 0 -
Press this button to activate color fade mode. Use buttons 1-9 to select your desired
show. Press this button twice for show 10. Press button 1 twice for show 11.
