ADJ MOD QW100, User Instructions

ADJ Products, LLC  -  www.adj.com  - MOD QW100 User Manual Page 23

Static Color Mode:

1.  Plug the fixture in and press the MODE button until “CLR MACS COLOR: XX” is displayed. “XX”    

    represents a number between 00-64.

2.  Use the UP and DOWN buttons to scroll through the 64 colors and find you desired color. After    

    you have found your desired color you can activate strobing by pressing the SET UP button to    

    enter the strobe mode.

3.   “STROB: XX” will be displayed, this is strobe  mode. The strobing can be adjusted between “00”   

    (flash off) to “15” (fastest flash).
System Reset:

This will return the fixture to its factory settings. 

1.   Plug the fixture in and press the MODE button until “OPTION” is displayed.

2.   Press the SET UP button until “SYSRESET” is displayed.

3.   Press the UP and DOWN buttons simultaneously to reset or press the MODE button to exit. 
Dimmer Curve:

This is used to set the dimming curve used with DMX mode. See page 26 for the different dimming 

curves. 

1.  Plug the fixture in and press the MODE button until “DMX MODE ADDR: XXX” is displayed.

2.  Press the SET UP button until “DELAY: X” is displayed. “X” represents the displayed dimmer  

    curve (0-4).

  •    0 - Standard

  •    1 - Stage

  •    2 - TV

  •    3 - Architectural

  •    4 - Theatre

3.  Press the UP or DOWN buttons to scroll through and select your desired dimming curve. 
DMX State:

This mode can be used as a precaution mode, that in case the DMX signal is lost, the operat-

ing mode chosen in the setup is the running mode the fixture will go into when the DMX signal is 

lost. You can also set this as the operating mode you would like the unit to return to when power is 

applied. 

1.  Plug the fixture in and press the MODE button until “DMX MODE ADDR:XXX” is displayed.

2.  Press the SET UP button until “DMX MODE NO” is displayed. The current DMX state will be 

   displayed.

  •  “BLACK” (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into    

    stand by mode.

  •  “HOLD” (Last State) - If the DMX signal is lost or interrupted, the fixture will stay in the last DMX    

      set up.    

  •  “AUTO” (Auto Run) - If the DMX signal is lost or interrupted, the unit will automatically go into  

      Auto Run mode.

  •  “MANUA” (Manual) - if the DMX signal is lost or interrupted, the unit will automatically go into the   

     last color set up in manual dimmer mode.

3.  Press the UP or DOWN buttons to scroll through and select your desired DMX state. 

MOD QW100

Operating Instructions