ADJ MOD QW100, User Instructions

ADJ Products, LLC  -  www.adj.com  - MOD QW100 User Manual Page 5

MOD QW100

Safety Precautions

•   To reduce the risk of electrical shock or fire, do not expose this unit rain or moisture

•   Do not spill water or other liquids into or on to your unit.

•   Do not attempt to operate this unit if the power cord has been frayed or broken. Do not attempt to   

   remove or break off the ground prong from the electrical cord. This prong is used to reduce the risk  

   of electrical shock and fire in case of an internal short.

•   Disconnect from main power before making any type of connection.

•   Do not remove the cover under any conditions. There are no user serviceable parts inside.

•   Never operate this unit when it’s cover is removed.

•   Never plug this unit in to a dimmer pack

•   Always be sure to mount this unit in an area that will allow proper ventilation. Allow about 6”  

   (15cm) between this device and a wall.

•   Do not attempt to operate this unit, if it becomes damaged.

•   This unit is intended for indoor use only, use of this product outdoors voids all warranties.

•   During long periods of non-use, disconnect the unit’s main power.

•   Always mount this unit in safe and stable matter.

•   Power-supply cords should be routed so that they are not likely to be walked on or pinched by  

   items placed upon or against them, paying particular attention to the point they exit from the unit. 

• Cleaning -The fixture should be cleaned only as recommended by the manufacturer. See page 29    

   for cleaning details.

•   Heat -The appliance should be situated away from heat sources such as radiators, heat registers,    

   stoves, or other appliances (including amplifiers) that produce heat.

•   The fixture should  be serviced by qualified service personnel when:

    A. The power-supply cord or the plug has been damaged.

    B. Objects have fallen, or liquid has been spilled into the fixture.

    C. The fixture has been exposed to rain or water.

    D. The fixture does not appear to operate normally or exhibits a marked change in performance.

    E. The fixture has fallen and/or subjected to extreme handling.