ADJ PAR Z MOVE, User Instructions

ADJ Products, LLC  -  www.adj.com  - Par Z Move User Manual Page 20

Service

 - 

This submenu has four functions: (1). Unit calibrattion (2). Activate the USB port 

power (3). Update the unit software (4). Reset the unit to default settings.

NOTE: ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THE CALIBRATION FUNCTION.

1.  Access the main menu and press the UP or DOWN buttons so that “Personality” is highlighted then   

  press ENTER. 
2.  Use the UP or DOWN buttons to switch between “Effect Adjust”, “USB Port Power” “Update    

 Software”, and “Factory Restore”. Press the ENTER button to select the function you would like  

  to adjust.
 -  Effect Adjust - This is the calibration adjustment function. The calibration for Pan, Tilt, and Zoom   

  can be adjusted. 

NOTE: ONLY QUALIFIED TECHNICIANS SHOULD PERFORM THE CALIBRATION    

 FUNCTION.

 -  USB Port Power - This is the power activation for the USB port. This function needs to be activated    

  to use the UPDATE SOFTWARE function.
 -  Update Software - This function is used for any future software updates. Check www.adj.com    

  and this units webpage for any software updates. Download the software update to a flash stick    

  and plug the flash stick into the Flash Drive slot located on the front of the unit. Contact ADJ  

  customer service for help when updating software.
 -  Factory Restore - This function will allow you to return the unit to its factory settings. Use the    

  UP or DOWN buttons to switch between “YES” or “NO”. Selecting “YES” and pressing ENTER    

  will reset the unit to its factory settings.
3.  Press the MENU button to exit.

Manual Control

 - This function will allow you to manually adjust the pan, tilt, shutter, 

dimmer, zoom, and special functions. NOTE: The “No DMX Status” setting MUST be set to 

“Manual” for this operational mode to work. Please see “No DMX Status” on page 16 for more 

information.

1.  Access the main menu and press the UP or DOWN buttons so that “Personality” is highlighted then   

  press ENTER.
2. Use the UP and DOWN buttons to switch between the available adjustable funcitons. Press the    

  ENTER button to select the function you would like to adjust.
3. Use the UP and DOWN buttons to adjust the values of the selected function. Press the ENTER    

  button after you have made your desired adjustments.
4. Repeat steps 2 & 3 to continue to make adjustments. Press the MENU button to exit.

Par Z Move

Operating Instructions