ADK-450 Administrator guide
رصعیلو نادیم : سردآ
کلاپ قیاقش نابایخ نایناریا ژاساپ بنج
8
دحاو
1
: نفلت
1811
8888
121
: سکاف
1111
8888
121
WWW.KAVOSHPHONE.COM
AMIR@KAVOSHPHONE.COM
@ADKPBX
30 / 86
·Call Forwarding(Follow Me)
This function sets inbound call forwarding on an extension. An administrator can
configure Call Forward for this extension.
· Volume Settings
Rxgain: The Volume sent to FXS extension.
Txgain: The Volume sent out by the FXS extension
·Call Waiting
Check this option if the extension should have Call Waiting capability. If this
option is checked, the “When busy” follow me options will not be available.
·Pickup Group
If this extension belongs to a pickup group, any calls that ring this extension
can be picked up by other extensions in the same pickup group by dialing the
Call Pickup feature code(the default is *8).
Note
: *8 is the default setting, it can be changed under Feature Codes ->
General -> Call
Pickup.
·Spy Settings
ADK-450 allows extension to monitor/barge in other conversation. Once this
feature is enabled, the extension has the ability to monitor/barge in other
calls using the feature codes for each spy mode. Refer to “Feature Codes”
section for more information.
·
spy modes
There are 4 spy modes available:
General spy: you have the permission to use the following 3 modes.
Quiet spy: you can only hear the call, but can't talk.
Whisper spy: you can hear the call, and can talk with the monitored extension.
Barge spy: you can hear the call and talk with them both.
·Hook Flash Detection
Sets the amount of time, in milliseconds, that must pass since the last hook-
flash event received by ADK-450 before it will recognize a second event. If a
second event occurs in less time than defined by Hook Flash Detection, then
ADK-450 will ignore the event. The default value of Flash is 1000ms, and it
can be configured in 1ms increments.
