Getting Started
7
2
Getting Started
This chapter describes the unpacking procedure of the subsystem
and installation procedures for CompactPCI boards and power
supply units (PSUs).
2.1 Shipping Contents
Check the shipping carton for any damage. If the shipping carton
and contents are damaged, please notify the dealer for a replace-
ment. Retain the shipping carton and packing material for inspec-
tion by the dealer. Obtain authorization before returning any
product to ADLINK.
Check that the following items are included in the package. If there
are any missing items, please contact your dealer:
X
One cPCIS-6418U Series Subsystem
X
Accessory Package: includes power cords for 110V and
220V wall sockets, replacement air filter, ergonomic rack-
mount handles, and pouch containing screws, zip ties, etc.
X
This User’s Manual
2.2 CompactPCI Card Installation
CompactPCI connectors are rigid, and therefore require careful
handling when inserted and removed. Improper manipulation of
the cards will result in damage to the backplane.
System slots usually have some obvious indicators, something
like red card guide rail, triangle mark enclosing the slot number on
the backplane. The system card only can be installed in the sys-
tem slot, and do not insert system card into any other slot, or insert
any peripheral card into system slot.
The handles on CompactPCI card helps users to install or remove
easily and safety. Please follow the procedures below to install a
CompactPCI module into a chassis:
Summary of Contents for cPCIS-6418U Series
