POST Codes
63
MI-960
5
POST Codes
The POST code checkpoints are the largest set of checkpoints
during the BIOS pre-boot process. The following table describes
the type of checkpoints that may occur during the POST portion of
the BIOS.
Note that checkpoints may differ between different platforms
based on system configuration. Checkpoints may change due to
vendor requirements, system chipset or option ROMs from add-in
PCI devices.
5.1
Post Code Checkpoints
Checkpoint
Description
03
Disable NMI, Parity, video for EGA, and DMA controllers. Initialize
BIOS, POST, Runtime data area. Also initialize BIOS modules on
POST entry and GPNV area. Initialized CMOS as mentioned in
the Kernel Variable "wCMOSFlags."
04
Check CMOS diagnostic byte to determine if battery power is OK
and CMOS checksum is OK. Verify CMOS checksum manually by
reading storage area. If the CMOS checksum is bad, update
CMOS with power-on default values and clear passwords.
Initialize status register A. Initializes data variables that are based
on CMOS setup questions. Initializes both the 8259 compatible
PICs in the system
05
Initializes the interrupt controlling hardware (generally PIC) and
interrupt vector table.
06
Do R/W test to CH-2 count reg. Initialize CH-0 as system
timer.Install the POSTINT1Ch handler. Enable IRQ-0 in PIC for
system timer interrupt. Traps INT1Ch vector to
"POSTINT1ChHandlerBlock."
07
Fixes CPU POST interface calling pointer.
08
Initializes the CPU. The BAT test is being done on KBC.Program
the keyboard controller command byte is being done after Auto
detection of KB/MS using AMI KB-5.
C0
Early CPU Init Start -- Disable Cache – Init Local APIC
C1
Set up boot strap processor Information
C2
Set up boot strap processor for POST
C5
Enumerate and set up application processors
Summary of Contents for MI-960
