Bios Configuration
•
57
Up to four IDE drives can be detected, with parameters for each
appearing in sequence inside a box. To accept the displayed entries,
press the “Y” key, to skip to the next drive, press the “N” key. If you
accept the values, the parameters will appear listed beside the drive
letter on the screen.
♦
Save & Exit Setup
This option allows you to determine whether to accept the
modifications or not. If you type “Y”, you will quit the setup utility and
save all changes into the CMOS memory. If you type “N”, you will
return to Setup utility.
ROM PCI/ISA BIOS
CMOS SETUP UTILITY
AWARD SOFTWARE, INC.
STANDARD CMOS SETUP
INTEGRATED PERIPHERALS
BIOS FEATURES SETUP
SUPERVISOR PASSWORD
CHIPSET FEATURES SETUP
USER PASSWORD
POWER MANAGEMENT SETUP
IDE HDD AUTO DETECTION
PNP/PCI CONFIGURATION
HDD LOW LEVEL FORMAT
LOAD BIOS DEFAULTS
SAVE & EXIT SETUP
LOAD SETUP DEFAULTS
EXIT WITHOUT SAVING
ESC : Quit
á
â
à
ß
: Select Item
F10 : Save & Exit Setup
(Shift) F2 : Change Color
Save Data to CMOS & Exit Setup
♦
Exit Without Saving
Select this option to exit the Setup utility without saving the changes
you have made in this session. Typing “Y” will quit the Setup utility
without saving the modifications. Typing “N” will return you to Setup
utility.ROM PCI/ISA BIOS
Save to CMOS and Exit (Y/N)? N
Summary of Contents for NuPRO-590 Series
