Installation
•
11
2.7
System Memory Installations
The NUPRO-710 supports three 128-pin DIMMs for SDRAMs or EDO
DRAMs of either 8MB, 16MB, 32MB, 64MB, 128MB or 256MB to form a
memory size between 8MB to 768MB.
IMPORTANT:
Do not mix SDRAMs or EDO DRAMs .
To use Error Checking and Correction (ECC), you must used a DIMM
module with 9 chips per side (e.g. 8 chips + 1 parity chips) and make the
proper settings in the BIOS Chipset Feature Setup.
Install memory in any combination as follows:
DIMM socket
168-pin DIMM Memory Module
DIMM Slot 1
8MB, 16MB, 32MB, 64MB, 128MB, 256MB
SDRAM or EDO
DIMM Slot 2
8MB, 16MB, 32MB, 64MB, 128MB, 256MB
SDRAM or EDO
DIMM Slot 3
8MB, 16MB, 32MB, 64MB, 128MB, 256MB
SDRAM or EDO
Total System Memory =
2.8
Expansion Card installations
First read your expansion card documentation on any hardware and
software setting that may be required to setup your specific card.
Expansion Card Installation Procedure
1. Read the documentation for your expansion card.
2. Set any necessary jumpers on your expansion card.
3. Carefully align the card's connectors and press firmly.
4. Setup the BIOS if necessary.
5. Install the necessary software drivers for your expansion card.
Assigning IRQs for Expansion cards
Some expansion cards need to use an IRQ to operate. Generally an IRQ
must be exclusively assigned to one use. In a standard design there are 16
IRQs available but most of them are already in use by parts of the system
which leaves 6 free for expansion cards.
Summary of Contents for NuPRO-710 Series
Page 2: ......
Page 4: ......
Page 6: ......
Page 12: ...4 Introduction 1 3 Board Layout Jumpers and Connectors NUPRO 710 NUPRO 711...
