142
Motion
Creator
General Purpose DI/O
X
Digital output: click the rectangle button to write the digital
output value for each digital output channel.
General Purpose AD/DA
X
Analog output: enter the analog output value in the textbox
then click the “Set Value” button to write the analog output
value.
X
The current value textboxes read back the current value of
two analog output channels automatically.
X
The AD0/AD1 will read back the current analog input value
of two channels.
External Encoder Setting
X
Mode: Select the attribute of each external encoder signal, if
the external encoder signals are connected.
X
Apply To: select the axis that uses the external encoder
X
Control Loop: select open or close loop control.
X
Parameter: enter the corresponding parameter for control
loop
Read and write encoder value
X
If the external encoder channels are used, and the signals
are connected, you can read the encoder value for each
channel.
X
Enter the new value of encoder in the textbox then click the
“Set” button to write the value.
5.4.2
Pulse Output Page
This SSCNET board provide two channels of pulse output func-
tion. Users can use these two channel to control stepper or any
other pulse input command motor.
Summary of Contents for PCI-8366+
