25
ASSEMBLY INSTRUCTION
_
For ATV-300
_
1.
Take out the battery and fill with acid liquid. Pre-charge the battery will
extend its life. The preparation and charge procedure is based on the
battery’s instruction.
2.
Install the rear wheels and parts in the following order:
A.
18x40x4.5mm washer (big)
B.
18mm hex-bolt (torque 450~550kg-cm, 44~54N-m)
C.
Cotter pin (open up the end after installed)
D.
Rubber cap.
3.
Install the front wheels and parts in the following order:
A.
18x40x4.5mm washer (big)
B.
18mm hex-bolt (torque 450~550kg-cm, 44~54N-m)
C.
Cotter pin (open up the end after installed)
D.
Rubber cap.
4.
Install the front bumper.