35
ASSEMBLY INSTRUCTION
1. Take out the battery and fill with acid liquid.
Pre-charge the battery will extend its life.
The preparation and charge procedure is based on the battery’s instruction.
2. Install the front and rear wheels and parts in the following order:
A. 18×40×4.5mm washer (big)
B. 18mm hex-bolt (torque 14 kg-m , 135 N-m)
C. Cotter pin (open up the end after installed)
D. Rubber cap.
3. Install the front bumper.
4. Set the handle bar into the steering base. Tie-up the 4 hex-socket bolts.
5. Pull the seat-lock and remove the seat. Install the battery with the red wire
to positive (+) and the black wire to the negative (-).
Summary of Contents for ATV50RS
