8
REMOVING THE CLEANER FROM THE POOL
■
Slowly pull the Admiral ATV-NAV’s power cord to retrieve the cleaner to the water surface and pool edge.
(DO NOT PULL THE CLEANER OUT OF THE POOL BY THE POWER CORD OR FLOATING SWIVEL).
■
Reach down and grasp the handle of the Admiral ATV-NAV and remove it from the pool as shown in Fig 1 and Fig 2.
Note: The unit should be stored in an area that will afford some protection from the elements to insure that it retains its finish.
CLEANING THE ROBOTIC POOL CLEANER’S FILTER BAG
Note: It is strongly recommended that the Admiral ATV-NAV’s filter bag should be cleaned after every use.
■
Turn the Admiral ATV-NAV upside down and place on the ground or stable surface so the bottom lid is exposed.
■
Locate the front and rear red retaining clips and unlock by turning as directed by the directional arrows as shown Figure 3.
■
Press the two red tabs inward towards the centre of the Admiral ATV-NAV as shown in Figure 4. Lift the cleaner’s bottom lid with the filter bag
up and out of the cleaner.
■
Grip the bottom lid of the Admiral ATV-NAV firmly, with one hand and use your other hand to grab the filter bag material and pull it away from
and up from the bottom lid of the cleaner. Remove all large debris from the filter bag. Refer Figure 5.
■
Turn filter bag inside out and hose out all remaining debris as shown in Figure 6. If filter bag is very dirty it may be washed in a
washing machine.
Note: When using a washing machine it is recommended to turn the filter bag inside out and wash using cold water (only) and a mild detergent
without any other item within the wash.
Note: Do NOT use a clothes dryer.
■
Hose all debris out of the Admiral ATV-NAV’s bottom lid being sure to remove all dirt from the fine filters situated on the intake doors as
shown in Figure 7.
■
To reinstall the Admiral ATV-NAV’s filter bag, first place cleaner bottom lid facing up wards.
■
Place the Admiral ATV-NAV’s filter bag outer frame onto the cleaner bottom lid and ensure the filter bag frame seats fully into the
retaining channels.
Note: Visually ensure the Admiral ATV-NAV’s filter bag is correctly seated into cleaners bottom lid retaining channels particularly the corners.
Refer Figure 8.
■
Once the filter bag frame is correctly positioned into the Admiral ATV-NAV’s bottom lid, retaining the filter bag is complete.
■
Pick up the Admiral ATV-NAV’s bottom lid and turn it over so the bag hangs down wards. Refit the cleaner’s bottom lid back into the cleaner
being careful to feed the cleaners filter bag back into the body of the cleaner.
■
Once the Admiral ATV-NAV’s bottom lid is seated press it firmly into the cleaner, the two red side tabs should click into place and turn the front
and rear red retaining clips as indicated by the directional arrows into the locked position, refer Figure 9. Gently pull on the cleaner bottom
lid to insure that it is properly locked in. The cleaner’s bottom lid is now correctly installed.
Note: Ensure the Admiral ATV-NAV’s filter bag is completely enclosed within the cleaner housing as the bottom lid will not close properly, and the
cleaner will not operate.
