4
III. ASSEMBLY
1. Take out your wheelchair from the packing box and put it on the
ground. Push the chair-frame apart to the left and right, and press
two tubes of on both sides of the seat base down into the groves on
both sides of the chair-frame
2. Flip up the push-handle to have the folding-levers snap into the folder
3. Plug both wiring harnesses of the batteries and the controller
4. Insert the tube on the lower end of the controller into the holder-tube on the re reverse side of
the left or right armrest which is chosen as you like, and adjust it in and out to a suitable position,
and then tighten it with the thumb-screw. Last, tie the tube with the cable by a plastic belt
5. Connect the wiring
harness plug of the
controller with the wiring
harness socket from the
batteries.
6. Insert the upper end of the left footplate from the outside of the wheelchair into the left
vertical frame-holder on the wheelchair front, and push the semicircle buckle on the lower end
of the footplate into the frame-holder, and then rotate the footplate forward so that a latch on it
will automatically insert into a pin hole. Then, unfold the footplate down. And then insert the
right footplate as the left one.
