PRIOR TO INSTALLATION CHECKLIST
IMPORTANT TIPS
This product must be installed by a qualified tradesperson and we would expect the installation to
be undertaken in a tradesperson like manner and finished to a tradesperson standard. This product
carries a full warranty against faulty workmanship and materials.
Please inspect thoroughly before installation to ensure that the product has not been damaged
and is correct. No claims for damage or incorrect items will be recognised after installation.
Check Products For Any Damages
Positioning & Ventilation
Check for Support Beams
Check for Plumb Walls & Level Floors
Check Plumbing Positions Align with Product Interior Configurations.
Please Note: If you cannot find the installation instructions for your ADP product in this booklet please go to
www.adpaustralia.com.au/installation-warranty to find applicable instructions.
Within 48 hours of receiving your goods, unpack your ADP
product and check for any possible freight damages or incorrect
items.
Please contact your place of purchase to report damages or
missing parts.
No claims for damages will be recognised after installation.
Please note: fixing screws/bolts are not supplied for installation.
Planning your bathroom furniture placement is critical.
Furniture must be at least 300mm away from any
wet areas. Materials used in the construction of our
furntiture units are moisture resistant, not water proof.
Do not expose furniture to shower spray.
It is important that your bathroom is adequatley
ventilated to eliminate moisture build up.
High humidity will lead to permanent dampness and
mould resulting in a deterioration of the materials in
your bathroom.
Wall hung furniture & basins require fixing to a support
beam fitted between the studs to give a solid wall backing
to attach the vanity to.
If necessary, fix additional support noggins at desired height
for cabinet and basin fixing prior to sheeting the wall.
Ensure total width of support noggin exceeds vanity width.
1
2
3
4
5
Ensure the wall is plumb and straight, ensure floor is level. If
you fix the product to a non-plumb wall or floor the following
could happen:
•
Your door or drawers will not operate correctly.
•
Door or drawers will not align.
•
Basins will not sit level, which may cause water to pool
or not drain properly.
If it is not possible to make the wall or floor plumb and
straight you must pack the vanity out so that it does not
follow the out of aligned wall.
Floor standing vanities must sit on a level floor or be packed
so they sit level and true.
Please note
if your vanity is fixed to a bowed wall, the
fastening of the fixings will force your cabinet to twist and
benchtop materials may crack due to increased stress on
joins and materials.
Please note
if your product has any electrical fittings
please allow for this and talk to your electrician
Take note of clearances behind drawers when
considering water supply fittings inside cabinet.
ENSURE ALL TILES EXTEND BEHIND AND BENEATH THE BATHROOM FURNITURE.
ADP do not recommend tiling in furniture due to moisture and mould build up which
can damage the material and void the warranty.
ALL AREAS WHERE CABINET/TOP MEETS WALL AND/OR FLOOR MUST BE SEALED
USING A NEUTRAL CURE SILICONE.
All edges where vanity top meets cabinet, wall or surrounding furniture must also be
sealed with a continuous bead of silicone.
Ventilation is
important to
prevent mould
& moisture
build up
300mm
(minimum clearance)
BATH
IT IS THE RESPONSIBILITY OF THE INSTALLER TO MAKE ANY ADJUSTMENTS TO
DOORS/DRAWERS AFTER INSTALLATION IF REQUIRED.
IT IS THE RESPONSIBILITY OF THE INSTALLER TO MAKE ANY ADJUSTMENTS TO
DOORS/DRAWERS AFTER INSTALLATION IF REQUIRED.
There may have been some movement in transportation and installation which causes
doors/drawers to become unaligned.
