INSTALLATION INSTRUCTIONS: ANTONIO METAL FRAME
Pre-drill hole locations
Apply silicone
Fix metal frame to wall through top rail
Pre-drill and fix metal frame to wall through
bottom rail
Apply silicone
Support Beam Location
Measure & mark vanity position
PLEASE NOTE
Mark vanity height
Support Beam
For FLOOR MOUNT installation go to Step 4
WALL HUNG:
Once the wall
has been sheeted, mark the
position of the support beam
on the wall.
WALL HUNG:
Mark on the wall the overall height
of the vanity (including top). Recommended
height is 850mm.
Measure down 150mm and mark wall, this will
determine the location of the screws/bolts in
frame. Mark a level line across the wall (approx
width of the vanity). Use a level to ensure accurate
line.
1
5
6
7
8
9
2
4
3
WALL HUNG:
It is recommended
that a
150 x 35mm
timber
support beam be pre-installed
into the framework prior to
sheeting the wall.
The recommended height of the
support beam is approximately
760mm from the finished floor
level.
This will determine the
overall height of the vanity.
4.2 - WALL HUNG:
Measure the positions of the pre-drilled holes on the top back rail of
metal frame. Mark these positions on your line.
4.2 - FLOOR MOUNT:
Place in position and adjust feet to level vanity. Mark position through
pre-drilled holes in top back rail.
4.1 - PRE-DRILL HOLES
Pre-drill holes in back rails, starting no further than 100mm from each
end of the frame and spacing the holes a maximum of 300mm apart.
Pre-drill hole locations into the wall. Be sure to use an
appropriate drill bit for your wall covering (tiles etc).
Make sure you have drilled into the support beam.
Apply silicone to all of the back surfaces of vanity, including
metal frame, drawer and shelf.
Secure vanity to the wall using appropriate screw/bolts through
the pre-drilled holes on the top rail.
Pre-drill your wall through the bottom rail hole locations and
secure metal frame to the wall using appropriate screw/bolt.
Where a stud or support beam cannot be located, use an
appropriately sized hollow wall anchor.
Note: It is not recommended to ONLY use hollow wall anchors
to fix vanity to the wall however these can be used if one or two
pilot holes do not penetrate into support beam.
76
0m
m
S UPPORT BEAM
Apply silicone to all top surfaces of the metal frame
(excluding the hand towel rail).
Apply silicone to back edge of ceramic top.
Place ceramic top on metal frame
10
Seal the external edges
11
Seal the external edges of ceramic top and bottom shelf to wall.
Allow silicone to set for 48 hours before use.
SUPPORT BEAM
Overall height of vanity
150mm
300mm
300mm
100
100
