OPC8000 series
14
© ADS-TEC GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
3 Operating and safety instructions
The device operates under electrical voltage and contains highly sensitive components.
Intervention by the user is required only for connecting the power supply lines. Should any
further modifications be required, it is necessary to consult either with the manufacturer
directly or with service personnel authorised by the manufacturer. The device must be de-
energised during work. Appropriate measures must be taken to prevent electrostatic
discharges on components. If the device is opened up by an unauthorised person, the user
may be subject to hazards and the warranty is invalidated.
General information
All users must read this manual and have access to it at all times.
Installation, commissioning and operation may only be performed by qualified
and trained personnel.
The safety notices and the manual itself must be observed by all persons who
work with this device.
At the installation site the valid guidelines and regulations for accident
prevention must be observed.
The manual contains the most important instructions on how to use this device
in a safe way.
Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.
The device can be cleaned by using a soft cloth and a commercially available
glass cleaning agent (e.g. Sidolin) with low alcohol content.
ATTENTION
To prevent damage to the device, all cable
lines (power supply, interface cables) must
be only be connected while the device is
switched off.
