VMT8000 series
10
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
3.6 Treatment and disposal of lithium batteries
This device contains a lithium battery for supplying the system clock with power as long as the supply
voltage is not connected. The battery has a life cycle of 3-5 years depending on which load is applied.
ATTENTION
Hazard due to thermal loads
The more the battery is exposed to higher
temperatures, the faster it ages.
Avoid thermal loads.
WARNING
Hazard due to explosion
Danger of explosion if using incorrect battery
types.
Use the battery type recommended by the
manufacturer.
Lithium batteries should not be exposed to fire, soldered, recharged, opened, short-circuited, reversed
or heated above 100 °C and they should be disposed of properly as well as protected against sunlight,
moisture and condensation.
The battery type to be used is:
½ AA 3V Lithium Battery Type: FDK Corp. CR14250SE
ads-tec part number: DZ-SONS-04100-0
The used lithium battery should be disposed of in accordance with local legal regulations.
3.7 Safety instructions
ATTENTION
Damage due to electrostatically sensitive
components
Damage to the device can be caused by
electrostatically sensitive components.
All installation and service work performed on
the device must be performed only under safe,
secure and de-energised conditions.
Recommendation for use:
Always adhere to the safety measures applicable when handling components at risk
of being damaged by electrostatic discharges.
The provisions of DIN EN 61340-5-1 / DIN EN 61340-5-2 apply
