OL-RS-BA
2020-09-25 © Automotive Data Solutions Inc. 2/6
shifter being put in gear after vehicle has been remote started.
• AVOID parking your vehicle on an inclined surface or an area surrounded by obstacles. For manual vehicles,
ALWAYS ensure the Reservation Mode sequence, as outlined in your Owner’s Manual, is correctly engaged prior
to the next remote start.
• AVOID delaying the inspection of your Omegalink system in the event of malfunction. Immediately contact a
Certified Technician to ensure that installation or defective equipment is properly addressed.
REMOTE STARTING FROM FACTORY KEY FOB
Your Omegalink system may enable remote engine start by performing one of the following button sequences
on your factory key fob:
BUTTON
FUNCTION
Press on
Start engine
Press on
Stop engine
OR
BUTTON
FUNCTION
Press on
Start engine
Press on
Stop engine
NOTE: This feature may not be supported on some vehicles. If supported, the chosen button sequence will be
communicated to you by your Omegalink Authorized Dealer at the time of installation. The remote start range
will be equal to your factory key fob’s door lock range.
ADJUSTING ENGINE RUNTIME SETTINGS
Once remote started from your factory key fob or long-range remote, your vehicle will run for the programmed
‘runtime’ setting. The default runtime is 15 minutes but it can also be programmed for 3, 5, 10, 25, 30 or 35
minutes. If you wish to change your remote start runtime setting, contact your Omegalink Authorized Dealer.
