08
The Centra HS Digital Label Printing System is shipped assembled, however it must be properly
unpacked, installed, and set up to run prior to operating. This manual will guide you through each of
these processes.
For your own safety, read this instruction manual before operating the equipment.
Knowledge of the machine’s components and specific hazards will minimize the possibility of
accidents and injury.
Wear proper clothing. Do not wear loose clothing, neckties, necklaces, or jewelry, which may be
caught in moving parts. Shoulder length hair and longer should be pulled back, and secured at all
times to prevent entanglement in equipment.
Keep your work area clean and well lit to prevent tripping or accidentally placing body parts in dan-
ger.
An Emergency Stop (E-Stop) push button located on the front of the machine near the cutter. Do
not use the E-stop to power off equipment unless there is an emergency. NOTE: The E-Stop only
powers off the systems printer base of the equipment. It does not power off the printer.
1.0 Introduction
1.0.1 Safety
Summary of Contents for iTech Centra HS
Page 2: ...02...
