2
5
DBC835 Wireless Doorbell Camera Installation
Basic Setup
This section provides information on how to assemble and
configure the DBC835 Doorbell Camera for enrollment.
1. Power Up and check the LED
Turn on the switch on the rear side of the doorbell camera and wait for
20 seconds until the LED turns to flashing red.
Note 1
: The internal battery usually could last 40 minutes of operation.
If you don’t see the camera powering up, please charge the doorbell
camera via Micro USB cable with USB charger for 2 hours before
installation.
Note 2
:
If the LED does not flash red, please hold the reset button for
15 seconds to factory default the camera then start the installation
process over.
Figure 3: Power LED
2. Enroll the Camera in ADT Pulse
This process is described in
Chapter 3 ADT Pulse Enrollment
.
3. Mount the Doorbell Camera
Mount the camera in its final permanent location. Please refer to
Chapter 4 Hardware Installation
for more details.
Installation
2
