– 12 –
PROMPTS ENTRY
OPTIONS
DESCRIPTION
30
GSM Flt Time
(00 mins)_
[00-99]
[00] = panel is
NOT notified
In the event the module detects a
communication path failure, enter the time
delay (in minutes) before the module notifies
the control panel with a trouble message.
The control panel can then notify the central
station. Enter 00 if you do not want this
module to notify the control panel of a
communication path failure.
UL NOTE:
Must be one (01) minute.
31
Review? Y/N
[Y] = review
[N] = exit
Reviewing Programming Mode Entries
To review the programming options (to
ensure that the correct entries have been
made), press [Y]. The programming prompts
are displayed again. Use the up/down arrow
keys to scroll through the program fields
without changing any of the values. If a value
requires change, simply type in the correct
value. When the last field is displayed, the
“REVIEW?” prompt again appears.
To exit the programming mode
, press [N]
in response to the "REVIEW?" prompt, and
refer to
Exiting Programming Mode
paragraph at the end of this section.
ECP Status Codes
The GSMVLP-ADT sends status messages to the control panel to indicate general failures. The control
will display “FAULT 103” if any of the events listed below should occur. In addition, the Contact ID
codes (listed in Appendix A) for these conditions are sent to the central station by the module.
•
GSMVLP-ADT loses communication with control panel.
•
GSMVLP-ADT lost contact with AlarmNet.
•
GSMVLP-ADT is not registered; account not activated.
•
GSMVLP-ADT shutdown.
Exiting Programming Mode
To exit the programming mode, press [N] in response to the "REVIEW?" question. Then press [Y] to the
"Exit Prog Mode?" question. Upon exiting, the message “Checking Root File TX Path” will be displayed,
and the configuration file at the server is updated to log the changes made. When complete, the
message "DONE" is displayed to indicate the file was successfully uploaded.
If critical configuration changes were made, such as the mode of operation, the GSMVLP-
ADT will reset to ensure that the programming features are enabled.
If the file is not successfully uploaded, one of the following prompts will be displayed. Follow the steps
shown below, until the upload is successful.
